Skip to Content

PIX-3000 xNT Device Ethernet board connection



There are four areas involved in setting up the Ethernet board they are: Ethernet board, ARP (Address Resolution Protocol), Telnet (a text interface used to communicate to TCPIP devices) and finally assigning the IP address to a Location within TruTime. These steps are discussed in the attached document with additional information being provided when needed.

Note: Please see attachment.


  • Attached Files
  • atvs_device_ethernet_connection_instructions.pdf (191.41 KB) 1113
  • Get notified when new articles are added to the knowledge base.

    Powered by PHPKB (Knowledge Base Software)