Articles Search Results

How to set up seven minute rule On Time Guardian version 4 or lower: Go to setup Wizard Pay policy tab Pay policy setup Rounding rules Select yes By default it will be set to 15/7 setting Read More

Attached are instructions on how to setup connection with peachtree Read More

How to verify communcation settings for direct connect in Hand Punch units Answer: Please check your connections. For com1 it will be connected with the serial 2 screw connection in the rear of your pc. Please secure connection at the HP te Read More

The attached provides a how to reset the MTX-15 from permanent error codes. Warning: When this procedure is performed on the clock, it will erase any data in the time clock device only - not the Time Guardian software in your co Read More

The attached is the how to reset handpunch terminals guide Read More

The attached document entails a how to hard reset the Hand Punch then reload employee maps or enrollments from the Time Guardian software - version 4 or lower. Read More

The below steps provides a how to hard reset on the MTX20 time clock only when there are permanent errors on the display 1. Reset button from left bottom rear if facing front of clock 2. Quickly press T of ENT a few times until DI Read More

The below steps will correct the issue of punches are on the wrong day for most employees. Applies to Time Guardian 5.x, Plus, and Pro 4.x. Verify the payclass assigned to the employee by... Going to Read More

To set printing settings for PIX or TCX and other mechanical clocks, use the linked manuals:  pix-55_operation_manual.pdf  ex-9000_operation_manual.pdf  pix-3000x_operation_manual.pdf Read More

How to move punches up a line or down a line when punch is on the wrong day and preventing total to be calculated Fix: Locate the punch to be moved, since it’s on the wrong day/line Highlight the punch Read More