HP Serial Connection Procedure for Time Guardian v5.0

 

1. Connect the hp terminal to the serial port com1 or com2
2. Then on time guardian (tg), go to
3. Edit > setup
4. Clock > yes, yes, no, yes
5. Click on location terminal
6. Click garbage if says fpt or mtx
7. Press the plus sign
8. Enter hp in name
9. Choose the term type as model of your hp
10. Go to connection tab, direct
11. Select com1 or 2
12. Next tab, terminal
13. Press add
14. Terminal # to 1
15. Change validation to default
16. Verify active is checked
17. Click green check mark
18. Press green check again
19. Press green check again
20. Go to communications
21. Highlight hp
22. 4 green buttons on bottom right
23. Press 2nd from left, this will set time - to test communication