VPN is only supported with *biometric clock models and any MTX30. Except for HP models, it’s recommended to set net speed to lowest or 10M. VPN between client workstations and server is not supported. VPN is allowed when accessing ... Read More
Handpunch series from Schlage will be discontinued in June. Important note: Any orders placed between today and June 15th will only have a 90 day warranty period. We are an official repair center for the Handpunch product and will continue ... Read More
Below are TCP ports that may be used by the Time Guardian software: 8080 for Apache 8443 for SSL 3051 for Firebird Database 3050 for Firebird Database (Amanonet) 2101 for Mtx15 ... Read More
Amano recommends these instructions on how to connect Time Guardian (TG) version 5, TG Plus, or TG Pro to HandPunch (HP) Terminal via Ethernet network. Use the following procedure: Set the IP, host bits (also subn... Read More
The below instructions applies to Time Guardian version 4 or lower versions on how to disable day light savings on the clock terminals: 1. Go to setup > ... Read More
How to sync ethernet HP and TG The below steps entails a how to sync ethernet Hand Punch and Time Guardian version 4.x or lower Connect HP to network, press clear + enter then password 2, se... Read More
How to verify how many enrollments or user space left on handpunch? Answer: Go to the clock Press Clear , enter ... Read More
The attached is a document that entails the wiring diagram for a Handpunch direct connection using the green molex connector - 3 wire Read More
How to sync HP and TG direct connect The below entails a how to sync Hand Punch and Time Guardian via direct connect serial via RS232 in the hand punch clock rear ports. The following steps are based on Time Guardian version 4.x and under.... Read More
I was wondering if you could help! I have a Hand Punch unit and I have accidentally deleted myself from the AMANO Clock as a Supervisor. Could you advice me How can I re-install myself as a Supervisor? Answer: ... Read More